HOME | PROFILE | CONTACT US | GALLERY
Snow Performance
Water Methanol Injection
detail picture (+)Stage 1 Diesel Boost Cooler™
This kit progressively injects more or less water-methanol, according to manifold boost pressure. The system is applicable for turbo diesels making up to 25psi of boost pressure. It has two dials to set the start and full points to tailor the delivery to your engines needs. Progressively injecting according to boost pressure allows for the most power over the widest range of rpms.
Kit includes:
• 150+ PSI High Volume Pump
• 2 Quart Reservoir
• Bulkhead Fitting
• Digital Variable Controller
• 2 Nozzles To Cover a Wide Range of Horsepower
• All Required Hardware Needed For Installation
• Comprehensive Instructions
detail picture (+)Stage 3 Diesel Boost Cooler™
The Stage 3 Diesel Boost Coolers™ are the most comprehensive water-methanol injection kits Snow Performance makes. This controller senses not only manifold boost pressure but also exhaust gas temperatures. Using two inputs allows for the smoothest injection control. More importantly, it also keeps the EGTs as low as possible – if they begin to climb, even if the boost stays constant, the Stage 3 controller will read this and inject more water-methanol to compensate. The adjustments to the delivery on the fly are accomplished with two easy-to-use push buttons, allowing for more or less injection, or switching from both boost & EGT referenced injection (smoothest, best for towing and EGT control) to just boost referenced injection (most responsive, best for performance and racing).
Kit includes:
• 150+ PSI High Volume Pump
• 2 Quart Reservoir
• Bulkhead Fitting
• Digital Variable Controller
• 3 Nozzles To Cover a Wide Range of Horsepower
• All Required Hardware Needed For Installation
• Comprehensive Instructions
detail picture (+)Stage 2 Gasoline Boost Cooler™
This kit uses manifold boost pressure to determine when and how much fluid to inject. Proportionally injecting according to boost pressure gives the most accurate delivery of water-methanol and allows the most cooling and performance improvement over the widest range. More power and driveability is the result. It can be used on any forced induction engine: carbureted, fuel injected, turbocharged, positive displacement or centrifugal blowers. The most suitable are the centrifugal supercharged and turbocharged engines, as they build boost is a more progressive manner concerning water-methanol injection. The positive displacement blower engines will work, but it might take more work to dial in the delivery. For higher boost applications (over 25psi), the controller can be upgraded to our VC100 unit.
Kit includes:
• 150+ PSI High Volume Pump
• 3 Quart Reservoir
• Digital Variable Controller
• 2 Nozzles To Cover a Wide Range of Horsepower
• All Required Hardware Needed For Installation
• Comprehensive Instructions
 |
©2008, REV Engineering |
|---|